SparkFun Forums

[jscoblic]

Sketch uses 14404 bytes (44%) of program storage space. Maximum is 32256 bytes.
Global variables use 738 bytes (36%) of dynamic memory, leaving 1310 bytes for local variables. Maximum is 2048 bytes.
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x00
Failed uploading: uploading error: exit status 1

I believe this is a board problem not Arduino IDE.

This is the second board I've tried. It worked at first now not.
Why is it so hard for you to post a workout for this where is can be found?

[jscoblic]

Ok, I tried a brand new board and still get this error message.

[paulvha]

Which boards do you use ?

[YellowDog]

Same error on 3 different boards? Doesn't sound like a board problem, sounds like a problem in the IDE or possibly a bad cable. It's very unlikely you have the exact same fault on all 3 boards.