- Sun Nov 19, 2023 4:35 pm
#245358
I have a problem with the openlog artemis. I want to log serial data over the rx/tx pins and power it with a LiPo Battery.
The datalogger works great while connected to my laptop but when I let it run over the battery no serial data gets logged to the sd-card.
I have connected a 450mAh LiPo Battery to the pins of the JST Connector with a switch in between to turn it on and off. There is as well a simblrtk2blite from ardusimple connected to the ground and 3.3V pins from the ola.
The battery is connected over the switch before disconnecting from my computer. I have also tried restarting the ola and as well the "stop logging" by pulling the pin 32 to ground (after enabling it in the settings) before reconnecting with my computer.
I'm pretty sure I have connected the battery right after measuring the voltage and the simplertk2blite works fine.
I am very grateful for your help.
The datalogger works great while connected to my laptop but when I let it run over the battery no serial data gets logged to the sd-card.
I have connected a 450mAh LiPo Battery to the pins of the JST Connector with a switch in between to turn it on and off. There is as well a simblrtk2blite from ardusimple connected to the ground and 3.3V pins from the ola.
The battery is connected over the switch before disconnecting from my computer. I have also tried restarting the ola and as well the "stop logging" by pulling the pin 32 to ground (after enabling it in the settings) before reconnecting with my computer.
I'm pretty sure I have connected the battery right after measuring the voltage and the simplertk2blite works fine.
I am very grateful for your help.