- Sat Jun 06, 2020 11:33 am
#215944
Hello all!
I recently got one of these fine boards along with the combo environmental sensor to monitor my 3d printer. When the OpenLog is hooked up to my computer or raspberry pi, everything seems to work as expected. However, when I operate it on battery power, it sometimes does not log anything to the SD card. It seems that the reset will fix it sometimes. The problem with that is, I have mounted this board in a case in a way that allows me to remove the SD card to access the log files. Doing this makes the reset button unavailable.
What is the reset button required for?
Should logging to the SD card on battery work without the reset button?
Can I work around the button with software?
Where is the best reference for this board?
Thanks in advance for any help with these! I am happy to provide picture or additional info if required
I recently got one of these fine boards along with the combo environmental sensor to monitor my 3d printer. When the OpenLog is hooked up to my computer or raspberry pi, everything seems to work as expected. However, when I operate it on battery power, it sometimes does not log anything to the SD card. It seems that the reset will fix it sometimes. The problem with that is, I have mounted this board in a case in a way that allows me to remove the SD card to access the log files. Doing this makes the reset button unavailable.
What is the reset button required for?
Should logging to the SD card on battery work without the reset button?
Can I work around the button with software?
Where is the best reference for this board?
Thanks in advance for any help with these! I am happy to provide picture or additional info if required