- Thu Feb 15, 2024 5:43 am
#247199
Hello, I have a Open Log Artemis (OLA) I would like to us as datalogger; to measure temp and humidity I would use the Spark X Aht20 that is in the list of automatically recognised sensor. I read all the documetation I found and updated successfully firmware and bootloader. Everything seem ok with the OLA and the AHT20 red power light is on. However I still have troubles in connecting the AHT20.
I receive the following error message:
Identifying Qwiic Muxes...
Identifying Qwiic Devices...
Known I2C address but device failed identification at address 0x38
Autodetect complete
I am pretty new of Arduino and I do not know how to solve that issue (likely an easy one), but I did not find the right way in internet and the forum, so I am asking here. Thank you for helping.
13:33:09.240 -> 3) Configure IMU Logging
13:33:09.240 -> 4) Configure Serial Logging
13:33:09.240 -> 5) Configure Analog Logging
13:33:09.240 -> 6) Detect / Configure Attached Devices
13:33:09.283 -> 7) Configure Power Options
13:33:09.283 -> h) Print Sensor Helper Text (and return to logging)
13:33:09.283 -> s) SD Card File Transfer
13:33:09.283 -> r) Reset all settings to default
13:33:09.283 -> q) Quit: Close log files and power down
13:33:09.283 -> x) Return to logging
13:33:11.688 ->
13:33:11.688 -> Menu: Configure Attached Devices
13:33:11.688 -> **No devices detected on Qwiic bus**
13:33:11.688 -> 1) Configure Qwiic Settings
13:33:11.724 -> 2) Detect Bio Sensor Pulse Oximeter: Disabled
13:33:11.724 -> x) Exit
I receive the following error message:
Identifying Qwiic Muxes...
Identifying Qwiic Devices...
Known I2C address but device failed identification at address 0x38
Autodetect complete
I am pretty new of Arduino and I do not know how to solve that issue (likely an easy one), but I did not find the right way in internet and the forum, so I am asking here. Thank you for helping.
13:33:09.240 -> 3) Configure IMU Logging
13:33:09.240 -> 4) Configure Serial Logging
13:33:09.240 -> 5) Configure Analog Logging
13:33:09.240 -> 6) Detect / Configure Attached Devices
13:33:09.283 -> 7) Configure Power Options
13:33:09.283 -> h) Print Sensor Helper Text (and return to logging)
13:33:09.283 -> s) SD Card File Transfer
13:33:09.283 -> r) Reset all settings to default
13:33:09.283 -> q) Quit: Close log files and power down
13:33:09.283 -> x) Return to logging
13:33:11.688 ->
13:33:11.688 -> Menu: Configure Attached Devices
13:33:11.688 -> **No devices detected on Qwiic bus**
13:33:11.688 -> 1) Configure Qwiic Settings
13:33:11.724 -> 2) Detect Bio Sensor Pulse Oximeter: Disabled
13:33:11.724 -> x) Exit